LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls (Introduction)) >> Repair Instructions >> Fuel Level Sensor Replacement - Left >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: DO NOT handle the level sender on the resistor card. Oils from human contact can damage the card.
  1. Remove the module from the fuel tank. Refer to Fuel Tank Module Replacement - Left .
  2. Press on the connector position assurance (CPA) with thumb and slide toward downward.
  3. Disconnect the electrical connector from the module.
  4. Remove the sender wires from the connector.
  5. Push in the locktab above the level sender body and slide the level sender out of the slot.
  6. Remove the level sender from the module. Ensure wires are routed into the slot in the back of the level sender body.
scientia non olet · About LEMON Manuals