LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls (Introduction)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Access Cover In Right Rear Wheelhouse
    GM561137Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the fuel tank pressure sensor rubber grommet with clean engine oil in order to aid in installation.
  2. Install the fuel tank pressure sensor into the top of the fuel tank.
  3. Connect the fuel tank pressure sensor electrical connector.
  4. Install the EVAP canister access cover.
  5. Install the right rear wheelhouse panel. Refer to Wheelhouse Liner Panel Replacement - Rear in Body Rear End.
scientia non olet · About LEMON Manuals