LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls (Introduction)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body
    GM43567Courtesy of GENERAL MOTORS CORP.
  1. Install a new throttle body gasket.
  2. Install the throttle body assembly.
    3. NOTE: Refer to the Fastener Notice in Cautions and Notices.
    IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
  3. Install the throttle body attaching bolts.

    Tighten:  Tighten the throttle body bolts to 10 N.m (89 lb in).

    4. Fig 2: Air Control Valve Electrical Connector
    GM1461904Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the air control valve electrical connector and the connector seal are properly installed and not damaged.
  4. Connect the air control valve electrical connector.
    5. Fig 3: Air Intake Duct & Clamp
    GM693173Courtesy of GENERAL MOTORS CORP.
  5. Install the air intake duct.
  6. Connect the mass air flow sensor electrical connector.
scientia non olet · About LEMON Manuals