LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the generator on the mounting bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

    3. Fig 1: Engine Wiring Harness Generator Lead Nut & Generator Electrical Connector
    GM651874Courtesy of GENERAL MOTORS CORP.
  3. Connect the generator electrical connector (1) and (2).
  4. Install the battery feed cable.
  5. Install the battery feed terminal nut (3).

    Tighten:  Tighten the battery feed cable nut to 13 N.m (10 lb ft).

    6. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
    Fig 2: Positive & Negative Battery Cable
    GM675304Courtesy of GENERAL MOTORS CORP.
  6. Install the drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 6.0L.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (7.0L) .
scientia non olet · About LEMON Manuals