Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the SIR through the I/P opening with the vinyl edge up and the harness on the right side of the vehicle.
- Insert the SIR guide pins in the I/P brace slots and rotate the round edge upward to align the bolt holes.
- Install the bolts securing the SIR to the I/P support beam.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Connect the yellow 2-way connector to the vehicle wiring harness.
- Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
- Turn the ignition on and verify that the SIR telltale operates properly.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.