LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Coil Replacement >> Repositioning Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repositioning Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Inflatable Restraint Steering Wheel Module Roll Connector
    GM891844Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SRS Sodium Hydroxide Powder Caution in Cautions and Notices.
    CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.
    IMPORTANT: In the event deployment has occurred, refer to Repairs and Inspections Required After a Collision .
    NOTE: If roll connector is not properly oriented to steering column assembly, it will be damaged.
    IMPORTANT: If the yellow tab is inadvertently removed during installation or removal and the roll connector hub has been rotated, it must be repositioned.
  1. Gently rotate the coil hub clockwise with the tab removed until a slight tension is present.
  2. Gently rotate the coil hub counterclockwise (count approximately 5 revolutions) until a slight tension is present
  3. Gently rotate the coil hub clockwise one half of the number of revolutions counted in step 2 (approximately 2.5 times).
  4. Rotate the smallest distance required to align the yellow tab.
  5. Install the yellow tab. Use tape is the tab is unavailable.
scientia non olet · About LEMON Manuals