Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Window

Courtesy of GENERAL MOTORS CORP.

Install the window, through the top of the door, to a regulator that is in the full up position.

Fig 2: View Of Door Window

Courtesy of GENERAL MOTORS CORP.

Align the rearward glass clamp within the alignment marks on the window.
Loosely tighten the rear window clamp nut.
With the aid of an assistant standing outside the vehicle position the window to the door opening.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

From inside the vehicle tighten the window clamps.
Tighten: Tighten the window regulator window clamp nuts to 10 N.m (89 lb in).

Fig 3: View of Window Clamp Access Plugs

Courtesy of GENERAL MOTORS CORP.

Open the door and install the window clamp access plugs.

Fig 4: Radio Speaker Assembly At Door

Courtesy of GENERAL MOTORS CORP.

Install the uppermost screw mounting the radio speaker assembly to the door.
Install the remaining screws in a criss-cross pattern.
Tighten: Tighten the door speaker assembly screws to 2.5 N.m (22 lb in).
Connect the electrical/audio connector.

Fig 5: Water Deflector At Door Inner Panel

Courtesy of GENERAL MOTORS CORP.

Install the water deflector.

Fig 6: View Of Door Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the door trim panel. Refer to Trim Panel Replacement - Driver Door or to Trim Panel Replacement - Passenger Door .
Perform minor height and tip-in adjustments as necessary. Refer to Window Height Adjustment - Door Minor or Window Tip-In Adjustment - Door .