LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Engine Controls - 3.4L - Introduction) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Pressure Sensor
    GM682671Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  2. Disconnect the fuel pump electrical connector (2).
  3. Remove the fuel level sensor electrical connector retaining clip (4).
  4. Disconnect the fuel level sensor electrical connector from under the fuel sender cover (5).
  5. Remove the fuel level sensor retaining clip.
  6. Squeeze the locking tangs and remove the fuel level sensor (3) from the modular fuel sender.
scientia non olet · About LEMON Manuals