LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Front End Sensor From Vehicle
    GM1345601Courtesy of GENERAL MOTORS CORP.
  1. Install the front end sensor to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 integral bolts that retain the front end sensor to the frame front crossmember.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  3. Connect the sensor electrical connector to the front end sensor.
  4. Install the CPA to the sensor electrical connector.
  5. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
scientia non olet · About LEMON Manuals