Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Inflatable Restraint I/P Module

Courtesy of GENERAL MOTORS CORP.

Install the inflatable restraint I/P module.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Use new bolts on the restraint module.

Install new bolts to the inflatable restraint I/P module.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the wire harness connector to the inflatable restraint I/P module.
Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 in SIR.
Deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Pretensioner Handling and Scrapping .