LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.
    CAUTION: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
    • The seat cushion frame
    • The seat recliner, if equipped
    • The seat adjuster
    • The seat back frame

    Failure to do so may cause future personal injury.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7  for the driver seat or SIR Disabling and Enabling Zone 9  for the passenger seat.
    2. Fig 1: View Of Seat Back Panel
    GM1506502Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Removal of the right or the left inflatable restraint side impact module uses the same procedure.
  2. Remove the seat back panel. Refer to Seat Back Panel Replacement - Front in Seats.
    3. Fig 2: Identifying Side Impact Module
    GM1506506Courtesy of GENERAL MOTORS CORP.
  3. Remove the nuts (1) from the inflatable restraint side impact module.
  4. Remove the module from the seat.
  5. Remove the connector position assurance (CPA) from the module electrical connector.
    6. Fig 3: View Of Inflatable Restraint Side Impact Module Electrical Connector
    GM792283Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electrical connector (1) from the module.
scientia non olet · About LEMON Manuals