LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Horn Ground/Contact Leads
    GM804488Courtesy of GENERAL MOTORS CORP.
  1. Connect the horn ground lead onto the steering wheel.
  2. Connect the inflator module electrical connector and the CPA.
    IMPORTANT: This vehicle is equipped with dual stage frontal air bags. Match the right color connector to the right color opening in the module. Route the driver inflator wires, the redundant control wires, and the horn wires correctly.
  3. Align the driver inflator module fasteners to the steering column fastener holes.
  4. Push the driver inflator module firmly into the steering column in order to engage the fasteners.
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
scientia non olet · About LEMON Manuals