Removal Procedure

Fig 1: Identifying Steering Column Electronic Lock Harness

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to SIR Caution in Cautions and Notices.

Disable the SIR system. Refer to the following procedures:
NOTE: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.
Remove the I/P Assembly. Refer to Instrument Panel (I/P) Assembly Replacement in Instrument Panel, Gages, and Console.
Disconnect the electrical connectors at the lock module.

Fig 2: Identifying The Lock Module In The I/P Carrier

Courtesy of GENERAL MOTORS CORP.

Remove the lock module by pulling the module up to release the retaining clips and sliding the module upward.