LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Cutaway 6.6 2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Computer/Integrating Systems >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Installing BCM Into Bracket
    GM923652Courtesy of GENERAL MOTORS CORP.
  1. Install the BCM (1) into the bracket.

    Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

    2. Fig 2: Disconnecting Electrical Connectors From Body Control Module
    GM923655Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connectors (2) to the BCM (1).
    3. Fig 3: Removing Right Side Knee Bolster Trim Panel
    GM853308Courtesy of GENERAL MOTORS CORP.
  3. Install the right side knee bolster trim panel. Refer to Knee Bolster Replacement - Right in Instrument Panel, Gages, and Console.
  4. If you replaced the BCM, program the module. Refer to Body Control Module (BCM) Programming/RPO Configuration .
scientia non olet · About LEMON Manuals