LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Epica LTZ >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.0L (L34 GMDAT) - Service And Repair >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. With the throttle valve closed, position the TP sensor on the throttle shaft. Align the TP sensor with the bolt holes.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of TP Sensor And Retaining Bolts
    GM1256154Courtesy of GENERAL MOTORS CORP.
  2. Install the TP sensor retaining bolts.

    Tighten:  Tighten the throttle position sensor retaining bolts to 2 N.m (18 lb in)  .

  3. Connect the TP sensor connector.
  4. Install the air intake tube and resonator.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals