Digital Radio Receiver Replacement

WARNING: This page is about a different car, the 2007 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Receiver Replacement - Digital Radio

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures: Remove the right rear quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement .
1	Digital Radio Receiver Nut NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Digital Radio Receiver Assembly Tip: Disconnect the antenna cable. Disconnect the electrical connector. Reprogram the digital radio receiver after installation. Refer to Control Module References .