Installation Procedure
WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the battery current sensor (2) by passing the ground end of the negative battery cable (1) through the sensor. Slide the current sensor to the battery end of the cable in order to encompass all ground wires attached to battery.
- Wrap electrical tape (3) around the battery current sensor (1) in order to secure the battery current sensor to the negative battery cable (4).
- Install the battery negative cable to the vehicle. Refer to Battery Negative Cable Replacement .
- Connect the battery current sensor electrical connector (2).
IMPORTANT:
Ensure the battery current sensor is installed in the correct direction and location on the negative battery cable. Also ensure that ALL grounding wires connected to negative post of battery pass through the sensor.