LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Crankshaft Position (CKP) Sensor Electrical Connector
    GM1554552Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector (1).
  4. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right (RPOs LZE/LZ4/LZ9) or Exhaust Manifold Replacement - Right (RPO LS4) .
  5. Perform the CKP system variation learn procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals