Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the strut.
Install the strut upper nuts.
Tighten: Tighten the strut upper nuts to 33 N.m (24 lb ft).

Fig 1: Identifying Upper Strut Mounting Nuts
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .
Install the strut lower bolts and nuts.

Fig 2: View Of Steering Knuckle To Strut Bolts
Courtesy of GENERAL MOTORS CORP.
Align the strut to the mark on the knuckle.
Tighten: Tighten the strut lower nuts to 130 N.m (96 lb ft).
IMPORTANT:
This is a prevailing torque type fastener. This fastener may be reused ONLY if:
- The fastener and its counterpart are clean and free from rust.
- The fastener develops 3 N.m (27 lb in) of torque/drag against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Align the front wheels. Refer to Measuring Wheel Alignment .