LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Front Suspension System) >> Repair Instructions >> Strut, Strut Component and/or Spring Replacement >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coil spring and upper strut mount to the J 45400  . See Special Tools .
    Fig 1: View Of Compressor Forcing Screw & Coil Spring
    GM743241Courtesy of GENERAL MOTORS CORP.
  2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
  3. Install the strut to the coil spring and upper strut mount.
  4. Install the strut retaining nut.

    Using the J 42991  and a 45 TORX® socket, install the strut mount nut. See Special Tools .

    Tighten:  Tighten the strut mount nut to 70 N.m (52 lb ft).

    Fig 2: Removing/Installing Strut Retaining Nut
    GM1079158Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Remove the strut from the J 45400  . See Special Tools .
  6. Install the strut to the vehicle. Refer to Strut Assembly Replacement .
scientia non olet · About LEMON Manuals