Installation Procedure

Fig 1: Removing/Installing Key Alarm Connector To/From Ignition Lock Cylinder Case

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition switch assembly (2) and secure by using 2 tapping screws (3).
Tighten: Tighten the screws to 7 N.m (62 lb in).
Install the ignition switch assembly connector (1) onto the ignition lock cylinder case (4).

Fig 2: Disconnecting/Reconnecting Theft Deterrent Control Module Connector

Courtesy of GENERAL MOTORS CORP.

Fig 3: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly

Courtesy of GENERAL MOTORS CORP.

Install the theft deterrent control module (2) onto the ignition lock cylinder case (1).
Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.