Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Yaw Rate Sensor & Nuts

Courtesy of GENERAL MOTORS CORP.

Position the yaw rate sensor in the vehicle (1).

NOTE: Refer to Fastener Notice .

Install the yaw rate sensor bolts (2).
Tighten: Tighten the bolts to 7 N.m (62 lb in).
Connect the yaw rate sensor electrical connector.
Install the HVAC Control Module. Refer to HVAC Control Module Replacement .
Install the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
Turn the ignition switch to the ON position, engine off.
Perform the Diagnostic System Check - Vehicle .