LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Yaw Rate Sensor/Lateral Accelerometer Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Yaw Rate Sensor & Nuts
    GM1236994Courtesy of GENERAL MOTORS CORP.
  1. Position the yaw rate sensor in the vehicle (1).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the yaw rate sensor bolts (2).

    Tighten:  Tighten the bolts to 7 N.m (62 lb in).

  3. Connect the yaw rate sensor electrical connector.
  4. Install the HVAC Control Module. Refer to HVAC Control Module Replacement in HVAC Systems - Automatic.
  5. Install the IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
  6. Turn the ignition switch to the ON position, engine off.
  7. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals