LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pushing The Steering Wheel Module Firmly Into The Steering Wheel
    GM1524133Courtesy of GENERAL MOTORS CORP.
  1. Connect the horn contact lead into the steering column cam tower.
  2. Connect the steering wheel module electrical connector and the CPA (4).
    IMPORTANT: This vehicle is equipped with dual stage air bags, you will find 2 connectors. Match the right color connector to the right color opening in the module. Route the steering wheel module wires, the redundant control wires, and the horn wires correctly.
  3. Align the steering wheel module fasteners to the steering wheel fastener holes.
  4. Push the steering wheel module firmly into the steering wheel in order to engage the fasteners.
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  6. After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping  for proper disposal.
scientia non olet · About LEMON Manuals