Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Transverse Spring Using J 33432-A

Courtesy of GENERAL MOTORS CORP.

Install the transverse spring compressor J 33432-A to the transverse spring. See Special Tools .
Install the transverse spring to the crossmember.
NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Transverse Spring Bolts, Retainers & Crossmember
Courtesy of GENERAL MOTORS CORP.

NOTE: Do not remove the transverse leaf spring compressor tool until after the shock absorber has been installed. The pad on the transverse leaf spring bolt could move out of position resulting in damage to the pad or a rattle in the suspension.
Install the transverse spring retainers and bolts (Use New Bolts) to the crossmember.
Tighten: Tighten the transverse spring retainer bolts (Use New Bolts) to 62 N.m (46 lb ft).

Fig 3: Lower Control Arm, Crossmember & Components
Courtesy of GENERAL MOTORS CORP.
Install the lower control arm to the front crossmember.
Install the cam bolts to the position that was marked during disassembly.
Due to a required wheel alignment, tighten the cam bolts but do not set to the final torque specification at this time.

Fig 4: Lower Control Arm Ball Joint Stud & Steering Knuckle
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use a new ball joint stud nut.
Install the lower control arm ball joint stud to the steering knuckle.
Tighten: Tighten the lower control arm ball joint stud nut to 30 N.m (20 lb ft) plus 180 degrees.

Fig 5: Lower Shock Absorber & Bolts
Courtesy of GENERAL MOTORS CORP.
Support the lower control arm with a jackstand.
Install the shock absorber lower mounting bolts.
Tighten: Tighten the shock absorber lower mounting nuts to 28 N.m (21 lb ft).

Fig 6: Stabilizer Shaft Link & Lower Control Arm
Courtesy of GENERAL MOTORS CORP.
Connect the stabilizer shaft link to the lower control arm.
Tighten: Tighten the stabilizer link nut to 72 N.m (53 lb ft).

Fig 7: Removing/Installing Transverse Spring Using J 33432-A
Courtesy of GENERAL MOTORS CORP.
Remove the J 33432-A transverse spring compressor from the transverse spring. See Special Tools .
Remove the jackstands from the lower control arms.
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Adjust the front trim height. Refer to Trim Height Specifications in Suspension General Diagnosis.
Perform a front wheel alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.