LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inflatable Restraint Side Impact Module Wiring Harness At Seat Frame With Retaining Clips
    GM1276234Courtesy of GENERAL MOTORS CORP.
  1. Install the module wiring harness to the seat frame while guiding the wiring harness through the appropriate spots on the seat frame.
  2. Install the wiring harness retaining clips to the seat frame.
    3. Fig 2: Seat Frame With Inflatable Restraint Side Impact Module & Retaining Bolts
    GM1276243Courtesy of GENERAL MOTORS CORP.
  3. Install the side impact module to the seat frame.
    4. Fig 3: Side Impact Module Retainer With Seat Back Cushion Cover
    GM1328112Courtesy of GENERAL MOTORS CORP.
  4. Install the side impact module retainer to the seat back cushion cover.
    5. NOTE: Refer to Fastener Notice .
  5. Install the retaining bolts to the side impact module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the seat back cover. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
  7. Install the front seat. Refer to Seat Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals