Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the strut.

Fig 1: Identifying Upper Strut Mounting Nuts
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .
Install the strut upper nuts.
Tighten: Tighten the strut upper nuts to 33 N.m (24 lb ft).

Fig 2: View Of Steering Knuckle To Strut Bolts

Courtesy of GENERAL MOTORS CORP.

Install the strut lower bolts and nuts.
IMPORTANT:
This is a prevailing torque type fastener. This fastener may be reused ONLY if:
- The fastener and its counterpart are clean and free from rust.
- The fastener develops 3 N.m (27 lb in) of torque/drag against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
Align the strut to the mark on the knuckle.
Tighten: Tighten the strut lower nuts to 130 N.m (96 lb ft).
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Align the front wheels. Refer to Measuring Wheel Alignment .