LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 205 (Front Suspension System) >> Repair Instructions >> Strut, Strut Component and/or Spring Replacement >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Compressor Forcing Screw & Coil Spring
    GM743241Courtesy of GENERAL MOTORS CORP.
  1. Install the coil spring and upper strut mount to the J 45400  . See Special Tools .
  2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
  3. Install the strut to the coil spring and upper strut mount.
    NOTE: Refer to Fastener Notice .
    Fig 2: Removing/Installing Strut Retaining Nut
    GM1079158Courtesy of GENERAL MOTORS CORP.
  4. Install the strut retaining nut.

    Using the J 42991  and a 45 TORX® socket, install the strut mount nut. See Special Tools .

    Tighten:  Tighten the strut mount nut to 70 N.m (52 lb ft).

  5. Remove the strut from the J 45400  . See Special Tools .
  6. Install the strut to the vehicle. Refer to Strut Assembly Replacement .
scientia non olet · About LEMON Manuals