LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Power Roof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the headliner. Refer to Headliner Replacement (Impala) or Headliner Replacement (Monte Carlo) .
  2. Disconnect the electrical connector from the motor/actuator.
  3. Remove the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .
  4. Remove the sunroof window. Refer to Sunroof Window Replacement .
  5. Manually slide the mechanism forward in the track until the mechanism reaches the hard stop.
    6. Fig 1: View Of Cam Assembly, Timing Hole & Lifter Arm
    GM1549379Courtesy of GENERAL MOTORS CORP.
  6. Push the cam assembly (2) forward until the timing hole (3) in the cam is aligned with the timing hole (4) in the lifter arm (1).
    7. Fig 2: View Of Pin & Drive Motor
    GM1549380Courtesy of GENERAL MOTORS CORP.
  7. Insert a pin (1) in the holes to hold the position while installing the drive motor.
    IMPORTANT: Both mechanisms should now be in the closed position.
  8. Repeat this procedure for the opposite side.
scientia non olet · About LEMON Manuals