LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Aveo Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls & Fuel - 1.6L - Introduction (2 Of 2) >> Repair InstructionsEngine Control Module Replacement >> Engine Control Module ReplacementRemoval Procedure >> Installation ProcedureCrankshaft Position System Variation Learn
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation ProcedureCrankshaft Position System Variation Learn

    Fig 1: Installing ECM To ECM Mount And Retaining Bolts
    GM1241941Courtesy of GENERAL MOTORS CORP.
  1. Position the ECM in place.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ECM to the ECM mount and install the retaining bolts.

    Tighten:  Tighten the ECM retaining bolts to 4 N.m (35 lb in).

  3. Connect the negative battery cable.
  4. Perform the following procedures:
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals