LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Aveo Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Shift Interlock System) >> Repair Instructions >> Shift Lock Control Solenoid Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lock solenoid on the assembly.
    2. Fig 1: Locating Shift Lock Solenoid
    GM1872313Courtesy of GENERAL MOTORS CORP.
  2. Install the shift lock solenoid retaining screws.
  3. Carefully install the shift select cover to the lever assembly.
    4. Fig 2: Shift Lever Control Knob Retaining Screws
    GM1872311Courtesy of GENERAL MOTORS CORP.
  4. Install the shift lever control knob, then the retaining screws.
    5. Fig 3: Shift Control Lever Assembly & Mounting Bolts
    GM1889696Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the shift control lever assembly and mounting bolts.

    Tighten:  Tighten the shift control lever assembly mounting bolts to 8 N.m (71 lb in).

    6. Fig 4: Control Cable Adjusting Nut
    GM1245812Courtesy of GENERAL MOTORS CORP.
  6. Connect the control cable to the shift control lever assembly.
  7. Tighten the control cable adjusting nut.

    Tighten:  Tighten the control cable adjusting nut to 8 N.m (71 lb in).

    8. Fig 5: Wiring Harness Connectors & Shift Control Lever
    GM1245816Courtesy of GENERAL MOTORS CORP.
  8. Connect the harness connector.
  9. Adjust the control cable. Refer to Range Selector Lever Cable Adjustment .
  10. Install the floor console. Refer to Front Floor Console Replacement (Notchback) or Front Floor Console Replacement (Hatchback) .
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals