Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 GMC Savana Special, 2006 GMC Savana Camper Special, 2006 GMC Savana, 2006 Chevrolet RV Cutaway, and 2006 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the yaw rate sensor/lateral accelerometer (1) to the vehicle.
- Install the nuts (2) retaining the yaw rate sensor/lateral accelerometer (1) to the vehicle.
Tighten: Tighten the nuts to 10 N.m (89 lb in).
- Perform the YAW rate reference table reset procedure. Refer to Yaw Rate Reference Table Reset Procedure .
- Connect the electrical connector (3) to the yaw rate sensor/lateral accelerometer (1).
- Install the carpet.
- Install the passenger seat to the vehicle. Refer to Seat Replacement in Seats.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.