LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.0L - Introduction (1 Of 2) >> Scan Tool Data List
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Scan Tool Data List

The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.

Use the Engine Scan Tool Data List only after the following is determined:

Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normal running engine.

IMPORTANT: A scan tool that displays faulty data should not be used. The scan tool problem should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.

Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Symptoms - Engine Controls for diagnosis.

The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:

All

The Parameter is in all of the data lists indicated below except Output Driver Data List.

Eng

Engine Data List

EE

Enhanced Evaporative Emission (EVAP) Data

FT

Fuel Trim Data List

H02S

Heated Oxygen Sensor (HO2S) Data List

Ign

Ignition System Data List

Ind

Induction System Data List

MF

Misfire Data List

OD

Output Driver Data List

TAC

Throttle Actuator Control (TAC) Data List

Scan Tool Data List

Scan Tool Parameter Data List Parameter Range/Units Typical Data Values
Engine Idling/Radiator Hose Hot/Closed Throttle/Park/Closed Loop/Accessories OFF
5-Volt Reference 1 Circuit Status EE, Ign, Ind, TAC OK/Fault OK
5-Volt Reference 2 Circuit Status EE, Ign, Ind, TAC OK/Fault OK
5-Volt Reference 1 EE, Ign, Ind, TAC Volts 4.5 V
5-Volt Reference 2 EE, Ign, Ind, TAC Volts 4.5 V
A/C Relay Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
A/C Relay Command Eng, Ind, MF, TAC On/Off Varies
Air Flow Calculated EE, Eng, FT, HO2S, Ind, MF, TAC Grams Per Seconds (g/s) 1-9 g/s @ idle
Ambient Air Temperature EE, Eng °C/°F Varies
APP Indicated Angle EE, Eng, FT, HO2S, Ign, Ind, MF, TAC 0-100% 0
APP Sensor 1 TAC 0-100% 0%
APP Sensor 2 TAC 0-100% 0%
APP Sensor 1 and 2 TAC Agree/Disagree Agree
APP Sensor 1 Indicated Position TAC % 0%
APP Sensor 2 Indicated Position TAC % -
APP Sensors TAC % 0%
BARO EE, Eng, FT, HO2S, Ign, Ind kPa 50-104 kPa/ Varies w/Altitude
BPP Circuit Signal Eng, TAC Applied/Released Released
BPP Signal TAC Applied/Released Released
Calculated TWC Temp Bank 1 FT, MF Degrees C/F 315-427°C (600-800°F)
Calculated TWC Temp Bank 2 FT, MF Degrees C/F 315-427°C (600-800°F)
Catalytic Converter Protection Active FT, HO2S Yes/No No
CKP Active Counter Ign 0-250 Counts Varies
CKP Resync Counter Ign Counts 0
CKP Sensor Ign RPM 500-700 RPM
CMP Active Counter Ign, MF 0-250 Counts Varies
CMP Sensor Ign RPM 1,000-1,400 RPM
Cold Start-Up Eng, EE Yes/No Varies
CPP Switch Eng, TAC Applied Released Released
Cruise Control Active Eng, TAC Active/Inactive Inactive
Cycles of Misfire Data MF 0-100 Counts Varies
Cylinder 1-8 IC Circuit Status MF, OD OK, Incomplete, Short B+, Short Gnd/Open OK
Cylinder 1-8 Injector Circuit Status MF, OD OK, Incomplete, Short B+, Short Gnd/Open OK
Decel Fuel Cutoff Eng, FT, HO2S Active/Inactive Inactive
Desired Idle Speed EE, Eng, Ind, TAC RPM ECM Controlled
Distance Since DTC Cleared Eng km/miles Varies
EC Ignition Relay Circuit Status OD, TAC OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
EC Ignition Relay Command Eng, TAC On/Off On
EC Ignition Relay Feedback Eng, TAC Volts 2.25-2.95 Volts
ECT Sensor All -39 to +140°C (-38 to +284°F) 88-105°C (190-221°F)
Engine Load All 0-100% 18% @ Idle
21% @ 2500 RPM
Engine Oil Level Switch Eng OK/Low OK
Engine Oil Pressure Sensor Eng, MF PSI 30
Engine Oil Pressure Switch Eng OK/Low OK
Engine Run Time All Hrs, Min, Sec Varies
Engine Speed All 0-10,000 RPM 500-700 RPM
Engine Speed Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK
EVAP Purge Solenoid Circuit Status EE, OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
EVAP Purge Solenoid Command EE, Eng, FT, HO2S 0-100% 10-25%
EVAP Vent Solenoid Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
EVAP Vent Solenoid Command EE, Eng Not Venting/Venting Venting
Extended Travel BPP Switch TAC Applied/Released Released
FC Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
Fuel Level Sensor Left EE 0-5 Volts Varies
Fuel Level Sensor Right EE 0-5 Volts Varies
Fuel Pump Relay Circuit Status Eng, OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
Fuel Pump Relay Command Eng On/Off ON
Fuel Tank Level Remaining EE, Eng, FT, MF 0-100% Varies
Fuel Tank Pressure Sensor EE, Eng -32.7 to +14.0 mm/Hg (-17.5 to +7.5 in/H2O) Varies
Fuel Tank Pressure Sensor EE 0-5.0 Volts Varies
Fuel Tank Rated Capacity EE 98 Liters (25.9 Gallons) or 96.2 Liters (25 Gallons) Varies with Fuel Tank Option
Fuel Trim Cell Eng, FT 0-23 19
Fuel Trim Learn FT Enabled/Disabled Enabled, May Toggle
Fuel Volatility EE, FT Low/Moderate/High Varies
HO2S Bank 1 Sensor 1 EE, Eng, FT, HO2S, Ind Millivolts 10-1,000 mV and Varying
HO2S Bank 1 Sensor 2 Eng, FT, HO2S Millivolts 10-1,000 mV and Varying
HO2S Bank 2 Sensor 1 EE, Eng, FT, HO2S, Ind Millivolts 10-1,000 mV and Varying
HO2S Bank 2 Sensor 2 Eng, FT, HO2S Millivolts 10-1,000 mV and Varying
HO2S BN 1 Sensor 1 Heater HO2S Amps 0.7-0.9 Amps
HO2S BN 1 Sensor 2 Heater HO2S Amps 0.4-0.6 Amps
HO2S BN 2 Sensor 1 Heater HO2S Amps 0.7-0.9 Amps
HO2S BN 2 Sensor 2 Heater HO2S Amps 0.4-0.6 Amps
HO2S BNK 1 Sen 1 Heater Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
HO2S BNK 1 Sen 2 Heater Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
HO2S BNK 2 Sen 1 Heater Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
HO2S BNK 2 Sen 2 Heater Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
HO2S Bnk 1 Sensor 1 Heater Command HO2S On/Off ON
HO2S Bnk 1 Sensor 1 Heater Command HO2S % 100%
HO2S Bnk 1 Sensor 2 Heater Command HO2S On/Off ON
HO2S Bnk 1 Sensor 2 Heater Command HO2S % 100%
HO2S Bnk 2 Sensor 1 Heater Command HO2S On/Off ON
HO2S Bnk 2 Sensor 1 Heater Command HO2S % 100%
HO2S Bnk 2 Sensor 2 Heater Command HO2S On/Off ON
HO2S Bnk 2 Sensor 2 Heater Command HO2S % 100%
Hot Open Loop FT, HO2S Active/Inactive Inactive
IAT Sensor All -39 to +140°C (-38 to +284°F) 35°C (91°F) Depends on Ambient Temperature
Ignition Accessory Signal Eng, TAC On/Off ON
Ignition 1 Signal All 0-25 Volts 11.5-14.5 Volts
Injector 1 - 8 Disabled Due To Misfire MF Yes/No No
Inj. PWM Bank 1 Eng, FT, HO2S, MF Milliseconds 2-6
Inj. PWM Bank 2 Eng, FT, HO2S, MF Milliseconds 2-6
Intake Manifold Pressure Eng, FT, Ind kPa/psi Varies
Knock Retard Ign 0.0-16°
Long Term FT Bank 1 EE, Eng, FT, HO2S Percentage Near 0%
Long Term FT Bank 2 EE, Eng, FT, HO2S Percentage Near 0%
Loop Status EE, Eng, FT, HO2S Open/Closed Closed
MAF Sensor All Grams Per Seconds (g/s) 1-9 g/s @ Idle, Depends on Altitude
15-26 g/s @ 2,500 RPM, Depends on Altitude
MAF Sensor Ind 0-31,999 Hz 1,150-1,350 Hz
MAP Sensor All kPa 20-48 kPa
MAP Sensor Ind Volts 1.0-2.0 Volts
Varies with Altitude
MIL Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
MIL Command Eng Off/On Off
MIL Requested by DTC All Yes/No No
Misfire Current Cyl. 1-8 MF 0-200 Counts 0
Misfire History Cyl. 1-8 MF 0-65,535 Counts 0
PNP Switch Eng P/N
Yes/No in gear
P/N
Power Enrichment Eng, FT, HO2S, MF Active/Inactive Inactive
Reduced Engine Power TAC Active/Inactive Inactive
Short Term FT Bank 1 EE, Eng, FT, HO2S Percentage Near 0%
Short Term FT Bank 2 EE, Eng, FT, HO2S Percentage Near 0%
Spark Eng, FT, HO2S, Ign, Ind, MF Degrees 10-17°
Starter Relay Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
Start-Up ECT EE, HO2S °C/°F Varies
Start-Up IAT HO2S °C/°F Varies
TAC Forced Engine Shutdown TAC Yes/No No
TAC Motor TAC Enabled/Disabled Enabled
TAC Motor Command TAC 0-100% 15-35%
Torque Management Spark Retard Ign Degrees
Total Knock Retard Ign Degrees
Total Misfire MF Counts Varies
TP Desired Angle TAC 0-100% 5.5%
TP Indicated Angle All 0-100% 5.5%
TP Sensor 1 Learned Minimum TAC Volts .55
TP Sensor 2 Learned minimum TAC Volts .55
TP Sensors 1 and 2 TAC Agree/Disagree Agree
TP Sensor 1 Indicated Position TAC % 5%
TP Sensor 2 Indicated Position TAC % 5%
Vehicle Speed Circuit Status OD OK, Incomplete, Short B+, Short Gnd/Open OK/Incomplete
Vehicle Speed Sensor All km/h
mph
0
Warm-Ups w/o Emission Faults Eng 0-255 Counts Varies
Warm-Ups w/o Non-Emission Faults Eng 0-255 Counts Varies
Warm-Ups Since DTC Cleared Eng Counts Varies
Wide Open Throttle TAC Yes/No No