LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Cutaway 6.6 2 >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement (w/JL4) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Brake Pressure Modulator Valve & Electronic Brake Control Module
    GM1381552Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use room temperature vulcanizing (RTV) or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install the EBCM (2) on to the BPMV (1).
    2. NOTE: Refer to Fastener Notice .
  2. Install the screws to the EBCM (2).

    Tighten:  Tighten the screws to 5 N.m (44 lb in) in an X-pattern.

    3. Fig 2: Identifying Chassis Electrical Connectors To EBCM
    GM924296Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors to the EBCM.
    4. Fig 3: View Of Splash Shield (Cutaway Vehicles)
    GM1209085Courtesy of GENERAL MOTORS CORP.
  4. For cutaway vehicles, install the splash shield.

    Tighten:  Tighten the splash shield bolts to 25 N.m (18 lb ft).

  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Revise the tire calibration using the Tire Size Calibration function.
  8. Verify correct system operation. Refer to Diagnostic Starting Point - Antilock Brake System .
  9. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals