LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Separating/Installing EBCM From BPMV
    GM255233Courtesy of GENERAL MOTORS CORP.
  1. Clean the BPMV surface with alcohol using a clean rag.
  2. Install the EBCM (1) to the BPMV.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 6 screws that attaches the EBCM to BPMV.

    Tighten: 

    • Tighten the top 4 mounting screws to 5 N.m (44 lb in). Tighten screws in an X pattern.
    • Tighten the bottom 2 mounting screws to 5 N.m (44 lb in).

  4. Connect the pump motor connector to the bottom of the EBCM.
    5. Fig 2: Identifying Electronic Brake Control Module
    GM1544732Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical harness connector (2) to the EBCM.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.5L.
  7. If a new EBCM was installed, the EBCM must be programmed. Refer to Electronic Brake Control Module Programming and Setup in Programming and Setup.
  8. Turn the ignition switch to the RUN position, do not start engine.
  9. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals