Pedal Positioning Module: Service and Repair

Adjustable Pedal Module Replacement

Removal Procedure

1. Remove the instrument panel (I/P) closeout panel.




2. Carefully cut and remove the tie strap securing the adjustable pedal module to the I/P support beam.
3. Remove the adjustable pedal module (1) from the side of the I/P support beam.
4. Disconnect the electrical connector from the adjustable pedal module.

Installation Procedure




1. Remove the old 2-sided tape from the I/P support beam.
2. If reinstalling the same adjustable pedal module, install NEW 2-sided tape to the module.
3. Connect the electrical connector to the adjustable pedal module.
4. Install the adjustable pedal module (1) to the side of the I/P support beam.
5. Install a NEW tie strap to secure the adjustable pedal module to the I/P support beam.
6. Install the closeout panel.