LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> HHR LS, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Data Communication System >> Diagnostic Information and Procedures >> Scan Tool Does Not Communicate with Class 2 Device >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Test for less than 1.0 ohm of resistance between the DLC ground circuit terminal 5 and ground.
    • If greater than 1.0 ohm, test the ground circuit for open/high resistance.
  2. Ignition OFF, disconnect the X1 harness connector at the PCM.
  3. Test for less then 5 ohms between the class 2 serial data circuit terminal 16 and ground.
    • If greater then the specified range, test the serial data circuit for a short to open/high resistance.
  4. Ignition ON, test for less then 1 volt between the serial data circuit terminal 16 and ground.
    • If greater then the specified range, test the serial data circuit for a short to voltage.
  5. If all circuits test normal, replace the PCM.
scientia non olet · About LEMON Manuals