Circuit/System Testing
WARNING: This page is about a different car, the 2010 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Antenna Circuit Testing
- Disconnect the harness connector at the antenna.
- Radio ON, verify a test lamp illuminates between the entertainment remote enable signal circuit terminal 1, and ground.
- If test lamp does not illuminate, test the circuit for short to ground or an open/high resistance. If circuit tests normal, replace the radio.
- Disconnect the antenna coax from the radio and the radio antenna.
- Test for infinite resistance between the antenna coax center terminal and ground.
- If less than the specified value, replace the antenna coax.
- Test for less than 5 ohms of resistance on the antenna coax center terminal from end to end.
- If greater than the specified range, replace the antenna coax.
- Test for less than 5 ohms of resistance on the antenna coax outer shield from end to end.
- If greater than the specified range, replace the antenna coax.
- Test for infinite resistance between the coax center terminal and the outer shield.
- If less than the specified value, replace the antenna coax.
- If all circuits test normal, replace the antenna.
- Ignition ON, radio ON, verify radio reception has improved.
- If there is still poor reception, replace the radio.