LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> HHR SS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L - Introduction (2 Of 2) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: ECT Sensor
    GM1713085Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the ECT.

    Tighten:  Tighten the sensor to 20 N.m (15 lb ft).

    2. Fig 2: Engine Wiring Harness Electrical Connector & ECT Sensor
    GM1826284Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (3) to the ECT sensor.
  3. Install the heat shield around the electrical connector, if necessary.
  4. Fill the cooling system as needed. Refer to Cooling System Draining and Filling (GE 47716 Fill) or Cooling System Draining and Filling (Static Fill-LNF) .
scientia non olet · About LEMON Manuals