Circuit/System Testing
IMPORTANT:
You must complete the Circuit/System Verification before proceeding with Circuit/System Testing.
- Test for less than 1 ohm of resistance between the low reference circuit and ground.
- If greater than 1 ohm, test the low reference for an open/high resistance. If the circuit tests normal replace the CMP Actuator solenoid.
- Test for less than 1 ohm of resistance on the high control circuit.
- If greater than 1 ohm, test the high control circuit for an open/high resistance. If the circuit tests normal, perform the Component Testing for CMP actuator solenoid.
- Inspect the CMP actuator. Refer to CAMSHAFT POSITION ACTUATOR MAGNET REPLACEMENT and CAMSHAFT POSITION ACTUATOR CLEANING AND INSPECTION .
- Inspect the engine timing components-Refer to TIMING CHAIN AND SPROCKETS CLEANING AND INSPECTION .