LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1016 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement (With RPO LAT) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EBCM-To-BPMV Retaining Bolts
    GM1234791Courtesy of GENERAL MOTORS CORP.
  1. Clean the sealing surface of the BPMV with denatured alcohol and a clean shop cloth.
  2. Carefully align the EBCM to BPMV electrical terminals and install the EBCM to the BPMV.
    3. Fig 2: View Of EBCM-to-BPMV Retaining Bolts
    GM1235278Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the 4 EBCM bolts. Tighten the bolts in a cross pattern.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

    4. IMPORTANT: Ensure the electrical connector is correctly inserted into the EBCM prior to placing the locking lever into position. Failure to make a proper connection may cause communication problems with the module.
  4. Connect the electrical connector to the EBCM.
    5. Fig 3: View Of Electrical Connector At EBCM
    GM1233230Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the electrical connector is correctly inserted into the EBCM prior to placing the locking lever into position. Failure to make a proper connection may cause communication problems with the module.
  5. Connect the electrical connector to the EBCM.
  6. If installing a new EBCM, it is necessary to program the EBCM. Refer to Control Module References .
scientia non olet · About LEMON Manuals