Circuit/System Testing
- Ignition OFF, and the MAIN fuse removed, disconnect the harness connector at the glow plug control module.
- Test for less than 5 ohms of resistance between the ground circuit terminal 7 and ground.
- If greater than the specified range, repair the ground circuit for an open/high resistance.
- Test for greater than 1 ohm of resistance between each of the glow plug circuit terminals and ground.
- Glow Plug 1 circuit terminal 4
- Glow Plug 2 circuit terminal 3
- Glow Plug 3 circuit terminal 2
- Glow Plug 4 circuit terminal 1
- If less than the specified range, repair the glow plug circuit for a short to ground.
- Install the MAIN fuse. Ignition ON, verify a test lamp illuminates between the ignition 1 voltage circuit terminal 6 and ground.
- If the test lamp does not illuminate, repair the ignition 1 voltage circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the glow plug control module.