LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> Optra LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L (Diesel) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying Fuel Suction Hose
    GM1866170Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful not to damage the fuel suction hose (1) while removing the fuel pump from the fuel tank and installing the fuel pump to the fuel tank. The broken fuel suction hose can cause incorrect fuel leveling.
  1. Remove the fuel pump assembly. Refer to Fuel Pump Replacement .
    2. Fig 2: Locating Connectors And Locking Tab
    GM1863902Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Pull the connectors while pressing the right side locking tab using a tool such as a flat screwdriver.
  2. Disconnect the fuel sender connector from the fuel pump assembly.
    3. Fig 3: Pressing Locking Tab
    GM1863903Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Pull the bracket while pressing the right side locking tab using a tool such as a flat screwdriver.
  3. Remove the fuel sender assembly bracket from the fuel pump assembly.
    4. Fig 4: Identifying Fuel Sender
    GM1863905Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Pull the sender body while pressing the right side locking tab using a tool such as a flat screwdriver.
  4. Remove the fuel sender by sliding it out.
scientia non olet · About LEMON Manuals