Engine Front Crossmember Replacement

Engine Front Crossmember Replacement (RWD)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disconnect the electrical wiring harness connectors from the engine crossmember.
3. Remove the engine crossmember mounting bolts.
4. Remove the engine crossmember.

Installation Procedure




1. Install the engine crossmember.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the engine crossmember mounting bolts and tighten to 120 Nm (89 lb ft).
3. Connect the electrical wiring harness connectors to the engine crossmember.
4. Lower the vehicle.