Rear Drive Axle

Rear Axle Lubricant Level Inspection (9.75, 10.5 and 10.75 Inch Axle)

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Ensure the vehicle is level.
3. Inspect the rear axle for leaks. Repair as necessary.
4. Clean the area around the rear axle fill plug.




5. Remove the rear axle fill plug.
6. Inspect the lubricant level.

The lubricant level should be between 0-6 mm (0-0.25 in) below the fill plug opening.

7. If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations (Service Intervals).

Caution: Refer to Fastener Caution (Fastener Caution).

8. Install the rear axle fill plug and tighten to 33 Nm (24 lb ft).
9. Lower the vehicle.