LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1331 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Caliper Guide Pin Bolts
    GM891307Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper to the brake caliper bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the brake caliper guide pin bolts (2) and tighten to 35 N.m (26 lb ft).
    3. Fig 2: View Of Front Brake Hose
    GM890982Courtesy of GENERAL MOTORS CORP.
  3. Remove the caps or plugs from the brake caliper opening and the brake hose.
    4. NOTE: Do not reuse the copper brake hose gaskets.
  4. Install NEW copper brake hose gaskets (2) to the brake hose-to-caliper bolt (1) and to the brake hose (3).
  5. Install the brake hose and the brake hose-to-brake caliper bolt to the brake caliper and tighten the bolt to 50 N.m (37 lb ft).
  6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  7. Remove the wheel nuts retaining the brake rotor to the wheel hub.
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
  10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  11. Slowly release the brake pedal.
  12. Wait 15 seconds, then repeat steps 10 and 11 until a firm brake pedal is obtained. This will properly seat the brake caliper piston and brake pads.
scientia non olet · About LEMON Manuals