Power Sliding Door Module Replacement
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Replacement of the PSDM requires that the power sliding door system be disabled by removing the PSD 15-amp fuse. Once the PSDM has been replaced and the fuse installed, the following initialization procedure must be performed for both sliding doors in the following order:
- Manually close and latch the power sliding doors.
- Perform two complete Open/Closed cycles for each sliding door using any one of the following devices:
- Appropriate switch mounted in the overhead console
- Appropriate switch mounted to the B pillar
- Remote Transmitter
- Special functions of the scan tool
- With a scan tool, verify that the PSD Open/Closed Position Learned parameter displays "Yes".
- Operate the power sliding door to verify completion of the procedure. Refer to Power Sliding Door (PSD) Description and Operation in Doors.