LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 623 (Sunroof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the sunroof window. Refer to Sunroof Window Replacement .

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    NOTE: Refer to Fastener Notice .
  2. Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .

    Tighten:  Tighten the motor attachment screws to 3.5 N.m (31 lb in).

  3. Connect the electrical connector to the motor/actuator.
  4. Remove the pin (1) from the holes that held the position while installing the drive motor.
    Fig 1: View Of Pin & Drive Motor
    GM1549380Courtesy of GENERAL MOTORS CORP.
  5. Install the headliner. Refer to Headlining Trim Panel Replacement (Impala) or Headlining Trim Panel Replacement (Monte Carlo) .
  6. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
  7. Verify the operation of the sunroof.