Sunroof Module Assembly Replacement

WARNING: This page is about a different car, the 2008 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sunroof Module Assembly Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Module Sunroof Bolt (Qty: 4) NOTE: Refer to Fastener Notice . Procedure: It is only necessary to lower the headliner. Only do those steps in headliner replacement that will lower the headliner enough to gain access to the parts. Refer to Headlining Trim Panel Replacement Tighten: 10 N.m (89 lb in)
2	Sunroof Module Procedure Transfer all parts as necessary to the new sunroof module. After installing the sunroof motor it will be necessary to perform the initialization/teach process. Refer to Sunroof Motor/Actuator Initialization/Teach Process .

Callout

Component Name

Module Sunroof Bolt (Qty: 4)

NOTE: Refer to Fastener Notice .

Procedure:
It is only necessary to lower the headliner. Only do those steps in headliner replacement that will lower the headliner enough to gain access to the parts. Refer to Headlining Trim Panel Replacement

Tighten: 10 N.m (89 lb in)

Sunroof Module

Procedure

Transfer all parts as necessary to the new sunroof module.
After installing the sunroof motor it will be necessary to perform the initialization/teach process. Refer to Sunroof Motor/Actuator Initialization/Teach Process .