LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> TrailBlazer 6.0 H, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 5.3L & 6.0L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: View Of Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS CORP.
  1. Reconnect the camshaft sensor (5) and the jumper harness (4).
  2. Install the O-ring (6) on the camshaft sensor assembly (4, 5).
  3. Reconnect the camshaft position sensor assembly (4, 5, 6) and the engine harness connector (3).
    4. NOTE: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
  4. Install the camshaft position sensor assembly (4, 5, 6) in the front cover (7).
    5. CAUTION: Refer to Fastener Caution .
  5. Install the camshaft position sensor mounting bolts and tighten to 25 N.m (18 lb ft).
  6. Install the generator assembly. Refer to Generator Bracket Replacement (5.3L and 6.0L Engines) .
scientia non olet · About LEMON Manuals